Measurement support
Doors and Patio doors
Measuring instructions for standard doors and sliding patio doors.
Measure the width
Measure the width of the frame opening at three different spots (W1, W2, W3). Always retain the smallest measurement. Do not deduct any tolerance.
Measure the height
Measure the height of the frame opening at three different spots (H1, H2, H3). Always retain the smallest measurement. Do not deduct any tolerance.
Required clearance
Check that an 18 mm clearance is available on the frame of your door or patio door to securely attach the guide profile.
Important: Installation between the roller shutter and the window
As the fly screen has a thickness of 18 mm, a clear gap of at least 18 to 20 mm is strictly required between your window and the roller shutter to install the system.
Installation tip: To facilitate installation, it should be possible to temporarily unscrew one of the roller shutter side tracks to smoothly slide the fly screen between the window frame and the shutter.
Tips for taking measurements
- Measure width and height at multiple spots, and always retain the smallest measurement.
- Do not deduct any tolerance; the ordered dimensions correspond to the manufacturing dimensions.
- If the measurements are identical at all points, you may deduct only 2 to 3 mm to facilitate installation.
Windows with no-drill installation
Measuring instructions for drill-free mounting models.
Measure the width
Take measurements directly from rubber seal to seal inside the window frame. Always retain the smallest measurement. Enter the exact width in mm, without adding or deducting anything.
Measure the height
Take measurements directly from rubber seal to seal inside the window frame. Always retain the smallest measurement. Enter the exact height in mm, without adding or deducting anything.
Tips for taking measurements
- Measure width and height at multiple spots, and always retain the smallest measurement.
- Do not deduct any tolerance; the ordered dimensions correspond to the manufacturing dimensions.
- If the measurements are identical at all points, you may deduct only 2 to 3 mm to facilitate installation.
The window frame must be completely smooth
Required compatibility: Ensure there are no grooves, bumps, ridges, or stops along the entire perimeter. The surface must be completely flat from end to end.
Incompatible configurations: This model is not suitable for sliding windows or double-sash windows. Any frame with a groove, curved profile, or extra thickness that might hinder installation is also incompatible.
Any doubts about your measurements or frame?
Send us a photo of your open window or patio door along with its seals. Our technical team will verify your setup's compatibility before you order.